Top page > Attaching a head to a body

Which neck type does your body have?


11cm body

21/23cm body

24cm body

27cm female body

27cm SBH body

27cm male slim body

40cm-50cm body

55cm/60cm body
Attaching a 1/6 scale head to a body
Attaching a 1/3 scale head to a body

If you have a 11cm body and a head with lid on top ...

How to apply a head (with lid on top) to the body

1. Unscrew the screw for the neck joint.

2. Remove the back part of the eyes so that they won't conflict with the neck joint.

3. Get a correct sized neck joint and screw it into the body.

　

  • When you use 11cm body, most heads have two options to attach a head. If you place the head on the higher indentation, the doll would have longer neck. And with the lower indentation, the doll will have shorter neck. When you attach Parabox S-Angela head to a 11cm body, the upper indentation would be recommended. Also, if you use Parabox Petite Fairy or Parabox Hikari head with a 11cm body, the lower indentation would be recommended.

  • When you use Parabox
    Petite Hime head or Parabox Chara
    head with a 11cm body,
    use a washer to fill in the gap.
    The washer comes with a body.

If you have a 21cm/23cm/27cm hard plastic body ...

How to apply a head (with lid on top) to the body

1. Unscrew the screw for the neck joint.

2. Remove the back part of the eyes so that they won't conflict with the neck joint.

3. Get a correct sized neck joint and screw it into the body.

If you have a 24cm body and a head with lid on top ...

How to apply a head (with lid on top) to the body

1. Using a screwdriver to unscrew it. It is easier to unscrew it if you tilt the neck on a 90 degree angle.

2.Remove the back part of the eyes so they won't conflict with the neck joint.

3.Obtain the right sized neck joint and screw it into the body.

If you have a 27cm SBH body and a head with lid on top ...

How to apply a head (with lid on top) to the body

1. Hold the bottom of the neck joint and turn it around slowly by lifting up to take it out.

2.Obtain the right sized neck joint and screw it into the body.

If you have a 1/3 body (40cm-60cm bodies) ...

How to apply a head (with lid on top) to the body

right: joint for 55cm - 60cm body/left: joint for the 40-50㎝ body
They are not interchangeable.

〇：As the above picture shows, Set the head skin by capturing it between the two neck pieces.

×：This example shows the wrong way. As the head skin is not captured, the head is not stable on the body.

Copyright 2004 ZAI Ltd. All rights reserved.

Ｔｗｉｔｔｅｒ