| How
to disassemble the female soft-bust type Obitsu body |
| | Tools
you need:- phillips head screwdriver
- hair
dryer (or something to heat with)
steps:
- Pull apart each part.
-
Opens up trunk.
- Change head attachment part.
|
| |
| 1: Pull apart each
part. | |
| 2: Opens up trunk. |
| |
|
|
| 1.Heating by a hair
dryer or hot water makes it easy to take the inside parts out of trunk. | 2.
Remove internal parts from trunk slowly. | 3.
This is what the internal parts will look like. | |
| |
|
|
| 4.Remove the screw
in the chest to separate the chest from the back. | 5.
Take apart the front part and back part of the chest, so that you reveal the head
attachment part and abdominal part. | 6.Remove the screw
in the abdominal part from the back. The picture above shows all of the individual
pieces. | |
| 3: Change head attachment
parts | | |
|
| |
1. To take out the neck attachment part, push the small
part through using a toothpick. | 2. Change to any
head attachment part as needed. | | |
| **When
joints or attached parts are loose, open it up and tighten screws to adjust.
**These vinyl products are disassembled easily after being softened using a hair
dryer or hot water.
***Be careful when you use heat to avoid injury. |
|
