| How
to disassemble the female normal type Obitsu body (same as clear type) |
| | Tools
you need:- phillips head screwdriver
- hair
dryer (or something to heat with)
steps:
- Pull apart each part.
-
Opens up trunk.
- Change head attachment parts
|
| |
| 1: Pull apart each
part. | |
| 2: Opens up trunk. |
| |
|
|
| 1.The front and back
parts of the chest are attached without screws. Push a slotted screwdriver into
the seam on the side of the chest and pry apart | 2.
After a little prying, you can open them up completely by hand. | 3.
These are the sections of the chest part after disassembly. | |
| |
|
|
| 4. Remove the head
attachment part and abdominal part from the chest part. | 5.
Disassemble the abdominal part.Use hair dryer to loosen the part if needed. | 6.
This is the abdominal part after disassembly | |
| |
|
|
| 7. The internal abdominal
part requires a screwdriver to separate it. | 8. This
picture shows all the parts disassembled. | 9. The way
to take the legs off the waist part is the same as other Obitsu body styles. |
|
| 3: Change head attachment
parts | | |
|
|
| 1.
Open up chest part, and unscrew the screw on the head attachment part. | 2.
Replace with the joint part that you need for your head. | 3.
Screw the screw that you unscrewed in step 1. | |
**When
joints or attached parts are loose, open it up and tighten screws to adjust.
**These vinyl products are disassembled easily after being softened using a hair
dryer or hot water.
***Be careful when you use heat to avoid injury. |
|
