Transplant
hair into soft head
Below is
an explanation
of the procedure to transplant hair into 1/6 scale unpainted
head.
We will create a bob hair style. Whatever style you are out
to achieve, imagine the hair design very well before starting.
The Obitsu head has a convenient line that marks the area
where you will transplant hair.
With a 60cm batch (30g), you could use all of it to make it
high dense. However, we used only half of it for this demonstration
without any sparse areas.
This project took
5 hours.
|
<Click picture to close up>
|
|
|
|
|
|
|
1. What we need
for this project
Obitsu W01 head and brown
hair
scissors, thick sewing needle (shorter is easier to handle.),
comb etc
|
2 Cut half into 30 cm pieces.
Tie both ends with thread to keep together.
|
3 :Pick 10 hairs out of the
batch.
|
4: Thread a needle.
|
|
|
|
|
|
|
|
5:Bring the needle into the
center of the hair.
|
6 Tie ends of hair together.
Easiest if several hair
loops are prepared ahead of time
|
7:stick the needle up through
the neck opening.
Start with the top of
the head. The soft vinyl head is easy to go thorough with needles.
The shorter needle is easier to handle.
|
8: Pull the needle all the
way.
|
|
|
|
|
|
|
|
9: Cut hair at top of loop
and remove needle.
|
10: Now you have completed
the first batch of approx. 15cm hair long hair!
|
11: Repeat Steps 3 to 10. Transplant
hair in a circular pattern.
|
12 Transplant hair in the front
of the scalp.
|
|
|
|
|
|
|
|
|
13:Then transplant the sides
and back of the head.
|
13: Make sure hair is transplanted,
completely filling the inside of the line mark..
The density of the hair will vary due to
your hair design and experience.
|
13:We pour some hot water to
settle hair down.
It is a good idea to set it up like the picture. Before the hot
water, the hair will have pointed upright.
|
|
|
|
|
 |
|
|
Pour
about 90 C (195 F) of boiling hot water on the hair. Repeat it
a couple of times. (take extreme caution when handling water as
severe injury could result)
|
The hair
should settle like this. Use hair dryer to dry the hair.
|
14: To create bangs ,transplant
more hairs to make a vertical line from the top of the head to
the forehead, and then add hairs horizontally from the vertical
line towards
the front.
|
15:Transplant more hairs to
make a vertical line from the center to the back.
Insert hairs in opposing directions to cover any bald areas.
|
|
|
|
|
|
|
|
|
16:Pour some hot water again.
Repeat several times.
|
17:Add more hair taking into
consideration the direction of the hairs.
|
Less sparse areas.
|
|
|
|
|
|
|
|
18:Add more hair.
Insert hairs to cover any bald areas.
|
19:Pour some hot water again.
Repeat several times.
|
20: Transplant is done.
|
No
more sparse areas.
|
|
|
|
|
 |
|
|
20:Trim hair as you want.
Bob cut has straight hair bang and simple
hair cut for side and back. Hair dressing scissors will create
nice hair cut if you have one.
|
The side
|
The top
|
If you like the hair style showing
the hairline, you need to transplant hair more densely.
|
|
| |
